Lab Bod Incubator
The lab bod incubator is double walled. The inner wall is made of Stainless Steel 304, while the outer wall is made of Mild Steel. The surface of the outer wall is coated with primer to protect it against rust as well as white stoved powder coated paint. Around 75mm thick glasswool is used for creating an insulation between the two walls for preventing loss of heat. There are 2/3 numbers of perforated stainless-steel shelves in the inner chamber, along with the ribs for adjusting shelves at required height. There is a double door system in the lab bod incubator; the inner door is made of transparent, thick, full-view glass and the outer door is a dual wall metallic with glass wool insulation in between. The accessories that are added along with doors are handle, lock, gasket and door operated illumination lamp. The complete incubator unit is mounted on castor wheels. There is a Digital temperature Indicator cum Controller with PT-100 sensor, which is used for electronically controlling the temperature range, between 5°C to 60°C. The time delay relay along with the controller controls the temperature maintenance accuracy mainly at + 0.5°C. The GI unit under the main chamber houses whole cooling unit. ISI mark strip type heaters perform heating. Two ISI mark Silicon binded motors connected to balanced blowers operating alternatively & continuously with heating & cooling, circulates the air. Lab bod incubator is provided with On/Off switch, digital controllers, indicators, etc.